一、安裝使用?
1、 Installation and use?
1、新沼氣燈使用前，先不安紗罩進行通氣試燒，若火焰呈淡藍色，短而有力，均勻地從泥頭孔中噴出，并發出呼呼的響 ，沒有脫火、回火等現象，表明燈的性能好。這時，可關閉沼氣閥門，待泥頭冷卻后即可安上紗罩。
1. Before using the new biogas lamp, it is necessary to put on the gauze cover for ventilation and trial firing. If the flame is light blue, short and powerful, it ejects evenly from the mud head hole and makes a whistling sound, and there is no phenomenon such as off fire and tempering, which indicates that the lamp has good performance. At this time, the biogas valve can be closed and the gauze cover can be installed after the mud head is cooled.
2、安裝紗罩時，應將其牢固地套在泥頭槽內，將石棉線繞扎兩圈以上，并打結扎牢后，剪去多余的線頭，然后將紗罩的褶皺拉直，使其分布均勻。
2. When installing the gauze cover, it should be firmly covered in the mud head groove, and the stone cotton wire should be wound for more than two circles. After being firmly tied, the excess thread head should be cut off, and then the folds of the gauze cover should be straightened to make it evenly distributed.
3、新紗罩初次點燃時，要求有較高的灶前壓力，有足夠的沼氣量將紗罩燒成球形。然后再點燈時，啟動的壓力應徐徐上升，以免沖破紗罩。
3. When the new hood is ignited for the first time, it is required to have high pressure in front of the stove and enough biogas to make the hood spherical. Then, when the light is on again, the starting pressure should rise slowly to avoid breaking the veil.
4、沼氣燈紗罩燃燒后，人造纖維被燒掉，剩下的是一層二氧化釷的白色網架。由于二氧化釷是一種有毒的白色粉末，一觸就破，所以燃燒后的紗罩不能用手摸或用其他物體觸擊。
4. After the biogas lamp gauze was burned, the man-made fibers were burned, and the rest was a white grid with a layer of thorium dioxide. As thorium dioxide is a kind of poisonous white powder, it can be broken at one touch, so the gauze cover after burning can not be touched by hand or other objects.
二、故障排除?
2、 Troubleshooting?
1、若紗罩外層出現藍色飄火，經久不消失，說明燃燒時帶進的空氣不足。應將燈盤順時針?lè)较蛐D(zhuǎn)，逐漸加大空氣進氣量。
1. If there is a blue floating fire on the outer layer of the gauze cover, it will not disappear for a long time, indicating that the air brought in during combustion is insufficient. The lamp panel should be rotated clockwise to gradually increase the air intake.
2、沼氣燈燃燒時，若紗罩不發白光而呈紅色，則是因?yàn)檎託馓倩蚩諝馓?。?yīng)將燈盤反時針?lè)较蛐D(zhuǎn)，逐步減少空氣進氣量，調至燈光 發白、亮度高為止。
2. When the biogas lamp burns, if the gauze cover does not emit white light and turns red, it is because there is too little biogas or too much air. The lamp panel should be rotated counterclockwise to gradually reduce the air intake until the light turns white and the brightness is high.
3、燈不發光，可能是噴嘴堵塞了，取下噴嘴，用縫衣小針將孔扎通即可。燈光一亮一暗，是輸氣管中積水較多或管道不暢通的緣故，可打開排裝冷凝水的閥門排除管道內的水或疏通管道。
3. The lamp doesn't light up. Maybe the nozzle is blocked. Take off the nozzle and tie the hole through with a small sewing needle. When the light is on and off, it is due to the accumulation of water in the gas pipeline or the blockage of the pipeline. The valve for discharging condensed water can be opened to drain the water in the pipeline or dredge the pipeline.
4、有時燃燒處于良好狀態，而燈不發白光，這是紗罩質量不佳或收藏時間過長受潮導致的，更換質量好的新紗罩即可。
4. Sometimes the lamp doesn't emit white light when the combustion is in good condition, which is caused by poor quality of the gauze cover or long storage time affected by moisture. It's enough to replace a new gauze cover with good quality.
魯公網安備37011202000764號號 網站地圖XMLTXT
企業二維碼
2021-05-26
